Sony WALKMAN PROFESSIONAL - Other Power Sources; House Current Power; 12 V Car Battery Power

OPERATION
1 Insert a cassette.
2 Set the TAPE selector to the appropriate
position.
3 For recording with Dolby B-type NR pro-
cess, set the DOLBY NR selector to
B-TYPE. For recording with Dolby C-type
NR process, set it to C-TYPE. For record-
ing without Dolby NR process, set it to
OFF.
4 Adjust the recording level following steps
4 to 7. Set the peaklbattery indication
selector to PEAK.
5 Depress the II button.
6 Depress the RECORD button.
7 Adjust the REC LEVEL control, referring
to the level meter.
8 Press the II button again to release the
pause mode. Recording will begin.
To listen to the sound being recorded,
connect the headphones.
To stop recording, press the +m button.
Recording levels for metal,
CrO, and normal
tapes are different. When recording with
metal tapes, the level meter should peak at
about
+6dB. For CrO, and normal tapes, the
peak level should be about
+3dB. The
peaklbattery indicator will show the highest
peak at the time for either the left or right
channel, whichever is higher at that instant.
HOUSE CURRENT
Use the Sony AC-D4HG AC power adaptor
(optional).
First connect the adaptor to DC IN 6V jack,
and then to a wall outlet.
Before connecting, be sure to read the in-
struction manual for the adaptor.
12V CAR BATTERY
Use the Sony DCC-127A car battery cord (op-
tional), and connect the DC IN 6
V jack on the set
to the cigarette lighter socket of a car. Set the volt-
age selector of the DCC-127A to 6
V. For further
details, refer to the instruction manual of the car
battery cord.
Notes
When the AC power adaptor or the car battery
cord is connected to the DC IN 6V jack, the
internal batteies (if present) are automatically
disconnected.
Use only the AC-D4HG AC power adaptor or
DCC-127A car battery cord. Do not use any other
AC power adaptor or car battery cord.