MAINTENANCE
SPECIFICATIONS
CLEANING THE HEADS
Clean the heads after every
10
hours of use to
enjoy optimum hi-fi stereo sound: moisten a
cotton swab or a soft cloth with denatured
alcohol, and gently wipe the parts shown
below.
recordlolayback head
DEMAGNETIZING THE HEADS
Either prolonged use, or an accidental con-
tact with a piece of magnetized steel (screw-
driver, scissors, etc.) will magnetize the
heads causing an increase in tape noise. In
such an event, demagnetize the heads using
a commercially available head demagnetizer.
CLEANING THE CASING
Clean the casing with a soft cloth slightly
moistened with water or a mild detergent
solution. Do not use solvents such as alco-
hol, benzine, or thinner as they may mar the
finish of the casing.
Recording system
4-track, 2-channel stereo
Wow and flutter
M.14% (DIN)
0.04% WRMS (NAB)
Tape speed deviation
M.3% (speed tuning OFF)
Speed tuner variations
Approx.
f4Y0
Frequency response
DOLBY NR OFF
With TYPE IV cassette
40
-
15,000 HZ
f
3 dB
With TYPE
II
cassette
40-15,000Hz*3dB
With TYPE
I
cassette
40
-
15,000 Hi!
k
3 dB
SIN (NAB, at peak level)
DOLBY NR C
TYPE
IV cassette
71 dB
TYPE
II
cassette
71 dB
TYPE
I
cassette
67 dB
DOLBY NR B
TYPE
IV cassette
65 dB
TYPE
II cassette
65 dB
TYPE I cassette
61 dB
DOLBY NR OFF
TYPE IV cassette
58 dB
TYPE
II cassette
58 dB
TYPE
l
cassette
54
dB
Total harmonic distorsion
0.9% with TYPE
IV cassette
Inputs MIC (PLUG IN POWER)
(stereo minijack)
x
1
0.25 mV with low impedance
microphone
LINE IN (stereo minijack) x 1
77.5
mV (47 kilohms)
To Next Page
Loading...
