Sony XM-C2000 - Fuse Replacement

«Protection circuit
This unit has a built-in protection circuit which
operates in the following cases when:
— the unit is overheated
— a DC current is generated
— the speaker terminals are short circuited.
When the protection circuit is activated, the
color of the POWER/PROTECTOR indicator
will change from green to red and the unit will
shut down. If this happens, turn off the
connected equipment and take out the
cassette tape or CD and determine the cause
of the malfunction. !f the unit has overheated,
wait until the unit cools off.
POWER/PROTECTOR
indicator
| Fuse Replacement _
If the fuse blows, check the power connection
and replace the fuse. If the fuse blows again
after the replacement, there may be an internal
malfunction. In such a case, consult your
nearest Sony dealer.
Warning
Use the specified amperage fuse.
Use of a higher amperage fuse may cause
serious damage to the unit.
—_
L]
Location Laem mel aleii(e)a me) m@re)aline) f-
HIGH/FRONT LEVEL (output) control
For adjusting the output level of the high
frequency audio signal or that of the front
speakers.
[2] MID/REAR LEVEL (output) control
For adjusting the output level of the mid
frequency audio signai or that of the rear
speakers.
[3] SUBWOOFER LEVEL (output) control
For adjusting the output level of the low
frequency audio signal.
[4] HIGH-MID CROSSOVER POINT (FRONT
HI-PASS) (filter selector) switch
3-way system: for selecting the crossover
frequency point (3.5K, 5K or 7KHZ) for the
high-mid-range audio signal. (The
frequencies below the selected point for the
high-range audio signal will be cut off. At the
same time the frequencies above that point
for the mid-range audio signal will be cut off
as well.)
2-way system: for selecting the crossover
frequency point (70, 100 or 140HZ) for the
front channels. (The frequencies below the
selected point will be cut off.)
HIGH/FRONT LEVEL CROSSOVER POINT
MID/REAR HI-PASS
SUBWOOFER LEVEL
HIGH-MID
(FRONT HI-PASS)
a.5K_5K_7KHZ
70 100 140HZ
70 100 140HZ
SUB WOOFER
LOW-PASS
70 100 140HZ
[5] MiD/REAR HI-PASS (filter selector) switch
For selecting the crossover frequency point
(70, 100 or 140HZ) for the mid-range audio
signal or that of the rear speaker outputs.
(The frequencies below the selected point .
will be cut off.)
{6]SUB WOOFER LOW-PASS (filter selector)
switch
For selecting the crossover frequency point
(70, 100 or 140HZ) for the jow-range audio
signal. (The frequencies above the selected
point will be cut off.}