– 2 –
TABLE OF CONTENTS
1. GENERAL
Button Locations ............................................................. 3
Setting the Clock ............................................................. 3
Installation ....................................................................... 4
Connections ..................................................................... 5
2. DISASSEMBLY ......................................................... 8
3. MECHANICAL ADJUSTMENTS ....................... 12
4. ELECTRICAL ADJUSTMENTS
Tape Deck Section .......................................................... 12
Tuner Section .................................................................. 13
5. DIAGRAMS
5-1. Notes for Printed Wiring Board and
Schematic Diagram ......................................................... 17
5-2. Printed Wiring Board – MAIN Section – ....................... 19
5-3. Schematic Diagram – MAIN Section (1/2) – ................. 21
5-4. Schematic Diagram – MAIN Section (2/2) – ................. 23
5-5. Printed Wiring Board – PANEL Section – .................... 25
5-6. Schematic Diagram – PANEL Section – ....................... 27
5-7. IC Pin Function Description ........................................... 31
6. EXPLODED VIEWS ................................................ 33
7. ELECTRICAL PARTS LIST ............................... 39
Flexible Circuit Board Repairing
• Keep the temperature of the soldering iron around 270 ˚C dur-
ing repairing.
• Do not touch the soldering iron on the same conductor of the
circuit board (within 3 times).
• Be careful not to apply force on the conductor when soldering
or unsoldering.
Notes on chip component replacement
• Never reuse a disconnected chip component.
• Notice that the minus side of a tantalum capacitor may be dam-
aged by heat.
To Next Page
Loading...
Need help?
General
