3
3. Power Up the Device
Connect the power adapter(s) and turn on the device
Connect the provided power adapter to connector 1 on the back of the device. In order
to increase redundancy you can connect an optionally available second power adapter
of the same type to power connector 2.
Turn the device on. The power switch is on the back of the device and is placed next to
the power connection.
During boot up the Status LED on the front will blink green. Once the device has booted
completely the Status LED will turn to solid green.
4. Configure the device
Use your browser to make the initial connection to the WebAdmin GUI
You will need to configure a workstation with the necessary LAN properties to access
WebAdmin. You can change these settings later to match your existing network. The
location of the menu for these settings depends on the operating system of your client.
Example: With Windows 7, the menu can be found under Start >> Control Panel >>
Network and Sharing Center
Start the browser and enter the management IP address of the appliance:
https://192.168.0.1:4444
Accept the security notice by clicking OK (Mozilla Firefox) or Yes (MS Internet Explorer).
For configuration you can follow the initial setup wizard described in the WebAdmin
Quick Start Guide
**
or cancel it and perform a manual setup (see the UTM
Administration Guide
*
).
Workstation connection properties:
IP address: Any address in the range 192.168.0.2
through 192.168.0.254
Netmask: Enter 255.255.255.0
Standard gateway: Enter the IP address of
the appliance’s internal network card E0/LAN:
192.168.0.1
DNS server: Enable this option and enter the IP
address of the internal network card E0/LAN:
192.168.0.1
* Available at www.sophos.com/en-us/support/documentation/sophos-utm
** Available via WebAdmin >> Support >> Manual
Quick Start Guide SG 105(w)/115(w)/125(w)/135(w) Rev. 3
To Next Page
Loading...
Need help?
General
