SOUNDMASTER iP4060BT - Clock Synchronization; Set the Alarm Timer; Repeat Alarm; Stop Alarm Ring

7
ENEN
Clock Synchronization
1. In the standby mode, press and hold the
MENU button on the remote control for few
seconds, then the unit will enter the CLOCK
 SYNCmode.
2. There are three clock synchronization modes
for chose:
 • iPod Only synchronize with the iPod/
iPhone/iPad.
 • RDS Only synchronize with the RDS radio
station.
 •OFF Turn o the clock synchronization
function, only adjust the clock
manually.
3. Then press the ENTER button to conrm.
Set the Alarm Timer
Youcansettwoalarmswhichgooatdierent
time.
1
Ensure that you have set the clock correctly.
2 Press and hold ALARM1 or ALARM2, on
remote or main unit for seconds [AL1 ] or
[AL2 ] begin to blink.
3 Press

/

on the remote control or
H
/
G
on main unit to select an alarm sound source:
iPod/iPhone/iPad, FM tuner, or buzzer.
4 Press ALARM 1 or ALARM 2. The hour digits
begin to blink.
5 Press

/

on remote or
H
/
G
on main unit
repeatly to set the hour.
6 Press ALARM 1 or ALARM 2. The minute
digits begin to blink.
7 Repeat steps 5-6 to set the minute.
8 Repeat steps 5-6 to select whether to ring
alarm the whole week, on weekdays, or at
weekend.
9 Repeat steps 5-6 to set the alarm volume.
Activate and Deactivate the Alarm Timer
Press ALARM 1 or ALARM 2 repeatly to activate
or deactivate the timer.
- If the timer is activated, [AL1 ] or [AL2 ]
is displayed.
- If the timer is deactivated, [AL1 ] or
[AL2 ] disappears.
Repeat Alarm
Youcanpresstoadjusttheintervaltorepeat
alarm. When the alarm rings, press SNOOZE/
DIMMER. The alarm repeats ringing 9 minutes
later.
Stop Alarm Ring
When the alarm rings, press the corresponding
ALARM 1or ALARM 2. The alarm stops but the
alarm settings remain.
View the Alarm Settings
Press ALARM 1or ALARM 2 to view the alarm
settings.
Set the sleep timer
This unit can switch to standby automatically
after a set period of time.
1 Press SLEEP repeatedly to select a set period
of time (in minutes).
- When the sleep timer is activated, the
display show , the volume will gradually
decrease before the unit power o.
2 Press SLEEP repeatedly until [OFF] is
displayed.
- When the sleep timer is deactivated,
disappears on the display.
Adjust Display Brightness
Press DIMMER repeatedly to select different
levels of display brightness.
Adjust Volume Level
During play, press the VOL+/- buttons to
increase/decrease the volume level.
Select a Preset Sound Eect
During play, press the EQ button repeatedly to
select: [FLAT], [POP], [CLASSIC], [ROCK], [JAZZ]
Mute Sound
During play, press the MUTE button to mute or
restore sound. Press this button again to cancel
the eect.