SOUNDMASTER iP4060BT - Listen to Music from Bluetooth Device; Listening to the FM Radio; Auto Scan and Save Preset Station; Tune to a Preset Radio Station

9
ENEN
3. Press and hold "PAIR " button on remote
control for a few seconds to activate
bluetooth pairing mode, display panel shows
"PAIR".
4. Search for bluetooth device with your device.
5. Select “iP4060BT” in the pairing list.
6. Enter default password “0000”, if the pairing
succeeds, display panel shows "BT" again.
7. To disconnect connection, turn o the
bluetooth function on your device or switch
the player to another source.
Tips:
- If a connection exist, hold and press " PAIR "
button on remote control for a few seconds to
re-activate the pairing mode, the connection
will be interrupted.
- If no other bluetooth device pairs with this
player within two minutes, the player will
recover its previous connection.
- The player will also be disconnected when
your device is moved beyond the operational
range.
- If you want to reconnect your device to this
player, place it within the operational range.
- If the device is moved beyond the operational
range, when it is brought back, please check
if the device is still connected to the player.
- If they are connected, display panel shows
"BT".
- If the connection is lost, display panel shows
"NO BT". Follow the instruction above to pair
your device to the player again.
Listen to Music from Bluetooth Device
• IftheconnectedBluetoothdevicesupports
Advanced Audio Distribution Prole (A2DP),
you can listen to the music stored on the
device through the player.
• IfthedevicealsosupportsAudioVideo
Remote Control Prole (AVRCP) ,
you can use the player's remote control
to play music stored on the device.
1. Pair your device with the player.
2. Start to play music via your device
(if it supports A2DP)
3. Use supplied remote control to
control play(if it supports AVRCP)
- To pause/resume play, press the
BF
button.
- To skip to a track, press the
H
/
G
buttons.
Listening to the FM Radio
Auto Scan and Save Preset Station
1 Tap the ON/OFF/SOURCE button repeatedly
on the unit or press the FM/BT button on the
remote control to select FM mode.
2 Press and hold the PROG button for a few
seconds to activate automatic programming.
All available stations are programmed in the
order of waveband reception strength.
- The rst programed radio station is played
automatically.
Tune to a Preset Radio Station
• Pressthe

or

buttons to select a preset
number that you want.
Tuning in a Station
• Tuneinradiostationsautomatically
- Press and hold the
H
/
G
buttons, the
frequency changes down or up automatically
until a station is found.
• Thesearchmaynotstopatastationwithavery
weak signal.
• Tuneinradiostationsmanually
- Press the
H
/
G
buttons repeatedly until
you nd the station you want.
• Ifreceptionisstillpoor,trytoadjusttheposition
of the aerial or try to move the radio to another
location.
Presetting Stations Manually
Youcanpresetupto20FMstations.
1 Tune in the desired station, then press the
PROG button.
2 Press the

/

buttons to select the preset
number.
3 Press the PROG button to store the station.
4 Repeat above steps 1 to 3 for each station
you want to store in memory with a preset
number.