Need help?Do you have a question about the Soundstream MC-300 and is the answer not in the manual?
General| 2-channel power output | 150 watts continuous per channel |
|---|---|
| 3-channel power output | 150 watts continuous mono |
| 4-channel power output | 75 watts continuous per channel |
| Total Harmonic Distortion | <0.1%, 20 Hz - 20 kHz |
| Signal-to-Noise Ratio | ~100 dS |
| Damping Factor | >200 |
| IHF Dynamic Headroom | 3 dS |
| Maximum Current Draw | 45 amps |
| Idle Current Draw | 2.5 amps |
| Input Sensitivity | 250 mV - 2.5 V |
| Frequency Response | 35Hz-280Hz |
Weight and Dimensions| Dimensions | 14-1/5” W x 2.3/5” H x 10” D |
|---|
Explains the dual "smart" power supply for thermal protection and fanless operation without overheating.
Specifies 12-Volt Negative Ground system requirement and checking compatibility.
Details power cable usage, direct battery connection, and dual 20A fuse requirement.
Explains direct, short, low-resistance chassis ground connection with 8-gauge wire.
Adjusting four independent input level controls for optimal gain settings based on channel mode.
Setting volume and input level controls to achieve balanced listening levels across channels.
How LSE compensates for speaker rolloff, extends deep bass, and its 6 dB/octave boost.
Variable frequency adjustment (35-280 Hz) for LSE boost, with caution for sensitive woofers.
Amplifier protection against overheating and short circuits, including "soft" thermal protection.
To Next Page