Soundstream VCD-21B - GENERAL OPERATION; Basic Operations; Menu and Settings Adjustment

GENERAL OPERATION
Turn Unit On/Off
Adjust Volume (VOL)
VOL VOL+ VOL-
Adjust Menu Options (SEL)
Press the power ( ) /MODE button on the front panel to turn on the unit, and long press it
again to turn off the unit.
Press the power ( ) button on the remote control to turn the unit on or off.
Rotate the knob on the front panel or press the / button on the remote
control to increase or decrease the volume level.
• Press repeatedly to cycle
through the following adjustable audio functions: BASS, TREBLE, BALANCE, FADER, EQ
FLAT/POP/ROCK/CLASS/OFF, LOUD ON/OFF, DX/LOC, STEREO/MONO and VOLUME.
Rotate
• Press and hold the
•
•
• the knob on the front panel or press the / button on the remote
control to adjust the selected item.
- BASS/TREBLE:-07,-06, ~, -01,00,+01,~, +06,+07
- BALANCE:L07,L06,~, L01, 00, R01,~,R06,R07
- FADER:R07,R06~,R01,00,F01,~,F06,F07
- EQ(Equalizer) Setting:OFF, FLAT, POP, ROCK, CLASS
- Loudness: LOUD ON/OFF
- DX/LOCAL: Enables or disables the local broadcast mode (LOCAL).
- Stereo/Mono: Switches between MONO and STEREO reception mode for radio
frequencies.
- Volume level:00,01,~,40
AREA EU/US,
- :This option allows you to preset a volume level as the power-on
memory volume level.
- VOL LAST: In this mode,the unit switches on at the actual volume it had when it
was last switched off.
- VOL ADJ: In this mode, the unit power on at the actual volume that you preseted a
constant switch-on volume level.
Press the button to enter the constant switch-on volume adjusting mode and
the “A-VOL XX” will be shown on the LCD display.
Then you can adjust a constant switch-on volume level by rotating the knob.
- AREA EU/US: This car radio is equipped the Europe / USA frequency.
Rotate the volume knob to switch between USA and europe frequency.
The system will change the frequecny setting in about 3 seconds.
-:
This unit is equipped with two types of clock display formats, 24 and 12 hours.
Rotate the volume knob to choose 24 hours format or 12 hours format.
- :Enables or disables the “BEEP” signal to confirm use.
• Rotate the knob on the front panel or press the / button on the remote
control to adjust the selected item.
1. To display clock time, press the button.
2. To set clock time, press and hold the button and the hour will flash.
the button on the front panel or on the remote control
button on the front panel or press the button on the remote
control to access these additional functions:VOL(LAS/ADJ), CLOCK 24/
12, BEEP ON/OFF.
VOL(LAS/ADJ)
CLOCK 24/12
BEEP ON/OFF
SEL
SEL SEL
VOL VOL+ VOL-
SEL
VOL
VOL VOL+ VOL-
Set the Clock (CLK)
CLK
CLK
5