Soundstream VR-732T - User Manual

Questions and Answers

B
Bradley CruzJul 31, 2025
Why is there no sound from my Soundstream VR-732T Car Receiver with amplifiers?
- M
  mindy81Aug 1, 2025
  If there is no sound output from your Soundstream Car Receiver when operating it with amplifiers or a power antenna, the power antenna lead may be shorted to ground, requiring excessive current, or there may be an issue with the remote on the amplifiers or power antenna. To resolve this: 1. Turn off the unit. 2. Remove all wires attached to the power antenna lead and check each wire for a possible short to ground using an ohm meter. 3. Turn on the unit. 4. Reconnect each amplifier remote wire to the power antenna lead one by one. If the amplifiers turn off before all wires are attached, use an external relay to provide remote-on voltage (excessive current required).
Y
yesenia51Aug 6, 2025
What to do if Soundstream Car Receiver sound is bad after turning on?
- H
  Henry JonesAug 6, 2025
  If the sound quality from your Soundstream Car Receiver is poor immediately after turning it on, it might be because the compact disc is dirty. Clean the compact disc without scratching it. Alternatively, the compact disc may be heavily scratched or warped, in which case you should replace it with a compact disc without scratches.
C
Crystal DrakeAug 12, 2025
Why Soundstream VR-732T sound is bad when power is turned on?
- D
  David BrooksAug 13, 2025
  If the sound from your Soundstream Car Receiver is poor right after you turn it on, it could be due to water droplets forming on the internal lens when the car is parked in a humid place. Let it dry for about 1 hour with the power on.
L
Louis Edwards DVMAug 18, 2025
How to fix a Soundstream VR-732T when the power does not turn on?
- K
  kristinasnyderAug 18, 2025
  If your Soundstream Car Receiver doesn't turn on and no sound is produced, it could be due to a blown fuse. Replace the fuse with one of the same amperage. If it blows again, consult your store of purchase. Another cause might be incorrect wiring, in which case you should consult your local retailer.
M
megan20Aug 25, 2025
What to do if buttons are not working on Soundstream VR-732T?
- M
  Mark LopezAug 26, 2025
  If nothing happens when you press the buttons on your Soundstream Car Receiver and the display is not accurate, it could be due to a microprocessor malfunction caused by noise. Turn off the power, then press the [no open] button and remove the DCP. Press the reset button for about 2 seconds with a thin rod. Alternatively, the panel or main unit connectors may be dirty. If so, wipe the dirt off with a soft cloth moistened with cleaning alcohol.