EasyManua.ls Logo

Soundstream VR-730 - User Manual

Soundstream VR-730
25 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
VR-730/ VR-730T
In-Dash 7 ” Monitor
Touch Screen
DVD/CD/MP3/MP4
AM/FM Radio
Built-in TV tuner
Owner’s Manual
Take the time to read through this owner’s manual.
Familiarity with installation and operation procedures will help you obtain the best
Performance from your new DVD-receiver.

Table of Contents

Questions and Answers

  • T
    Thomas RoyAug 11, 2025
    Why is there no sound output from my Soundstream VR-730 with amplifiers attached?
    • T
      tranjosephAug 11, 2025
      If there is no sound output when operating your Soundstream Car Receiver with amplifiers or a power antenna attached, the power antenna lead may be shorted to ground, requiring excessive current, or there may be an issue with the remote on the amplifiers or power antenna. Here's how to troubleshoot: 1. Turn off the unit. 2. Remove all wires attached to the power antenna lead and check each wire for a possible short to ground using an ohm meter. 3. Turn on the unit. 4. Reconnect each amplifier remote wire to the power antenna lead one by one. If the amplifiers turn off before all wires are attached, use an external replay to provide remote-on voltage (excessive current required).
  • L
    Lindsay LawrenceAug 20, 2025
    What to do if Soundstream VR-730 Car Receiver power does not turn on?
    • L
      lesliedennisAug 20, 2025
      If your Soundstream Car Receiver doesn't turn on and no sound is produced, the fuse may be blown. Replace it with a fuse of the same amperage. If the fuse blows again, consult your store of purchase. Also, check for incorrect wiring and consult your local retailer.
  • R
    rmuellerAug 31, 2025
    What to do if buttons on Soundstream VR-730 Car Receiver are not working?
    • K
      kelly51Aug 31, 2025
      If nothing happens when you press the buttons on your Soundstream Car Receiver and the display is not accurate, it could be due to a microprocessor malfunction caused by noise. Turn off the power, then press the [no open] button and remove the DCP. Press the reset button for about 2 seconds with a thin rod. Alternatively, the panel or main unit connectors might be dirty. Wipe the dirt off with a soft cloth moistened with cleaning alcohol.

Soundstream VR-730 Specifications

General IconGeneral
Display TypeLCD
BluetoothYes
Radio TunerAM/FM
Rear Camera InputYes
DIN SizeDouble DIN
SD Card SlotYes
Steering Wheel Control CompatibleYes
Channels4
Built-in AmplifierYes
Built-in EqualizerYes
CD PlayerNo
Auxiliary InputYes
Remote ControlYes
Audio Formats SupportedMP3
Power Output50W x 4
Peak Power Output50W x 4

Related product manuals