---------------·~~-~-
....
*"'*\>,
Select a number and press enter button to make a calling. Press the PB-DOWN button,
phonebook will be updated and downloaded with new phonebook.
nti-theft
s
stem
Remove the panel
1.
Press the PWR button to turn the power off.
2.
Press OPEN button to detach the panel.
3.
Pull the panel out.
4. Place the panel into the case and take it with you when you leave the car.
Remove the unit
1.
Remove the panel and the trim plate.
2.
Insert both T-Keys into hole on the front
of
the set until they lock.
3.
Pull out the unit.
NOTE:
The source unit will turn off if the control panel is open longer than 60 seconds.
The LED light on the inner panel will twinkle
in
red when the ACC power
is
cut off.
Handlin
& Cleanin DISC
Handling
- . Dirty, scratched or warped discs may cause skipping or noise.
To keep the disc clean, only handle the disc by its edges.
Discs should be stored
in
their cases after use to avoid
scratches.
Do not expose discs to direct sunlight, high humidity, high
temperature or dust.
Prolonged exposure to extreme temperature can warp the
disc (such as leaving the discs
in
your car
in
summer heat).
Do not stick or write anything
on
either side
of
disc. Sharp writing instruments, or the ink used
in
some felt-tip pens, may damage its surface.
Do not touch.the unlabelled side. Do not attach any seal, label or data protection sheet to
either side
of
a disc.
Cleaning
DISC
Fingerprints should be carefully wiped from the surface
of
disc
with a soft cloth. Unlike conventional records, compact discs
have no grooves to collect dust or dirt, so gently wiping them
with a soft cloth should remove most dust or stains. Wipe
in
a
straight motion from the centre to the edge.
CAUTION: Never use thinner benzene, record cleaner or anti-static spray
on
a compact disc.
Such chemicals can damage its plastic surface.
22
To Next Page
Loading...
