Time Period Programming
PROGRAM BUTTON
Page 10
Overview
OWNER'S MANUAL
Press the PROGRAM button to enter the
time period programming screens.
The blinking icon(s) on the display may be
changed by pressing the COOLER or
WARMER button.
After the blinking icon is changed to the desired
selection, press the NEXT button.
Each item in the time period programming screens will flash
and can be modified with the COOLER & WARMER buttons.
Continue the steps above until programming is complete.
Press the PROGRAM button twice to exit the programming
screens and operate the thermostat according to the time
period programming. Then press the MODE button to run
the program in the Heat, Cool, or Heat & Cool mode.
Press the PROGRAM button once to exit the programming
screens and operate the thermostat as a manual heat or cool
only thermostat.
S1-THEM22P7S
To Next Page
Loading...
Need help?
General
