Advanced Setup
This is normally done by the installer at initial installation.
Press NEXT
to advance
Press NEXT
to advance
Press NEXT
to advance
Page 15
Press NEXT
to advance
OWNER'S MANUAL
Select backlight operation
when a button is pressed:
ON: Light continuously.
OFF: Light for 8 seconds
after a button press.
Use these buttons to
adjust the deadband
from 1 to 6 degrees
(page 17).
Press the PROGRAM button to enter the Advanced Setup.
When the clock is flashing, press the NEXT button for
5 seconds. Do not release the button until this screen
appears.
2
HEAT
COOL
Use these buttons to
select fan operation.
On for continuous
operation.
Auto for heating or
cooling operation only.
Use these buttons to
adjust the minimum
difference between
cooling & heating
setpoints.
(0 - 6 )
Continued
FAN
Auto
S1-THEM22P7S
To Next Page
Loading...
Need help?
General
