Mono In, Mono Out
This is the most common use case. Plugging the incoming signal into INPUT 1 with OUTPUT 1
connected to an amp (or the next device in the signal chain) produces a standard mono signal. Dual
processing effects are also mixed down a single output.
Mono In, Stereo Out
This is a very common use case that allows you to create some nice stereo imaging from a single
mono instrument input or use your EQ2 as a splitter to send your signal to two separate outputs.
Note that if Split mode is enabled, you can set up two entirely different equalizer curves for each
output. When the unit is bypassed in this mode, it will automatically switch to Soft Bypass mode to
maintain the bypass signal on the Channel 2 output.
To Next Page
Loading...
