Source Audio L.A. Lady Overdrive - External Switch Configuration; Hot Hand Input and Config

SA244 L.A. Lady Overdrive User’s Guide 21
(about 4 blinks per second). Note that you may control one or more knobs with the external
switch, up to six total knobs.
6. Move the knob(s) you wish to control with the expression pedal to the minimum desired
position, then click the ON/OFF FOOTSWITCH. The CONTROL LED will now be lit solid red.
7. After setting the minimum and maximum knob positions, the parameter mapping is
complete.
Hot Hand Input
The Hot Hand 3 Wireless Effects Controller can be connected directly to the L.A. Lady’s CONTROL INPUT
for motion control of the L.A. Lady’s effects parameters. The Hot Hand has two axes of expression: X
and Y. These signal are carried on the two rings of the TRRS cable that comes from the Hot Hand
receiver.
Configuring the Hot Hand
When the Hot Hand is connected to the L.A. Lady, follow these simple steps to calibrate it and map it
to control different effect parameters.
1. Press the CONTROL INPUT BUTTON to turn on Control Input mode. The CONTROL LED should be
lit green.
2. Press and hold the CONTROL INPUT BUTTON until the CONTROL LED begins to blink slowly
(approximately one blink per second).
3. Move the Hot Hand ring over the range of motion you would like to use to control the L.A.
Lady. The easiest way to do this is to move the ring in the same way that you intend to move
it as you perform. The L.A. Lady will intelligently select the X or Y axis of the Hot Hand
automatically, based on the motion of the ring.
4. After setting Hot Hand range of motion, click the L.A. Lady’s ON/OFF FOOTSWITCH once. The
calibration is now complete, and the CONTROL LED will blink faster (about 2 blinks per
second). Now, it is time to map the Hot Hand to the effect parameters.
5. Move the knob(s) you wish to control with the Hot Hand to their minimum desired position,
then click the L.A. Lady’s ON/OFF FOOTSWITCH. The CONTROL LED will now blink even faster
(about 4 blinks per second). Note that you may control one or more knobs with the Hot
Hand, up to four total knobs.
6. Move the knob(s) you wish to control with the Hot Hand to their maximum desired position,
then click the L.A. Lady’s ON/OFF FOOTSWITCH. The CONTROL LED will now be lit solid green.
Note that you may control one or more knobs with the Hot Hand, up to four total knobs.
Ground Power
Y Exp X Exp