• Only qualified persons should operate the Southwire
®
Extreme
Duty Tension Monitor – 10K
• Wear eye protection, hard hat, cut resistant gloves, and safety
toe shoes when using this tool.
• Do not use tool when tired or under the influence of drugs,
alcohol, or medication.
• Keep body parts and loose clothing away from moving parts.
• Always follow operating procedures.
• Do not use this tool near live circuits. Shut off and lock out
power when working near existing circuits.
• Do not expose tool to rain or use in wet or damp locations.
FAILURE TO OBSERVE THESE WARNINGS CAN RESULT
IN SEVERE INJURY OR DEATH.
WARNING:
Personal Safety Hazards
WARNING
• Read and understand all instructions and safety information in
this manual before operating or servicing this tool.
3
IMPORTANT SAFETY INFORMATION
4
IMPORTANT SAFETY INFORMATION
• Disconnect from power source and turn off before servicing or
dismantling the Tension Monitor.
• Turn off the tool when not in use.
WARNING:
Electrical Shock Hazards
FAILURE TO OBSERVE THESE WARNINGS CAN RESULT
IN SEVERE INJURY OR DEATH.
FAILURE TO OBSERVE THESE WARNINGS COULD
RESULT IN SEVERE INJURY OR DEATH
WARNING
: Entanglement Hazard
• Do not operate this tool while wearing loose-fitting clothing.
Retain long hair.
• Keep hands away from rope and rollers. Rope can crush a hand.
FAILURE TO OBSERVE THESE WARNINGS COULD
RESULT IN SEVERE INJURY OR DEATH
WARNING
: Tool Use Hazards
• Use this tool for manufacturer’s intended purpose only.
Use other than what is described in this manual can result in
injury or property damage.
• Inspect all aspects of the pull to ensure safety.
• Only qualified personnel should use pulling equipment and
Southwire
®
Extreme Duty Tension Monitor – 10K .
To Next Page
Loading...
