• Read and understand all the instructions and safety information
in this manual before operating or servicing this tool.
Description of Operation and Features
Southwire
®
Extreme Duty Tension Monitor - 10K is designed to
monitor cable-pulling tension during the cable installation process
and provides continuous digital display readout of cable pulling
tension, max tension alarm, distance pulled, elapsed time, and also
data-log to a USB flash drive for review later. Each unit is made
with an anodized aluminum frame for durability.
5 6
DESCRIPTION OF OPERATION AND FEATURESDESCRIPTION OF OPERATION AND FEATURES
FAILURE TO OBSERVE THESE WARNINGS COULD
RESULT IN SEVERE INJURY OR DEATH.
CAUTION
• Do not use if any parts are damaged as this can cause an unsafe
condition and lead to tool malfunction or failure.
• If tool is in disrepair, DO NOT USE. Have tool serviced at an
Authorized Southwire
®
Repair Center.
• Do not pull anything other than the pulling rope through the force
gauge. Metallic objects such as pulling grips and clevises will
damage the rollers.
• Do not pull wire rope through the pulleys except when using
hardened steel pulleys available through Southwire
®
.
• Failure to observe this precaution may result in damage to the
Southwire
®
Extreme Duty Tension Monitor – 10K.
FAILURE TO OBSERVE THESE WARNINGS COULD
RESULT IN SEVERE INJURY OR DEATH
CAUTION
Contains FCC ID: A8TBM71S2
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Contains transmitter module IC: 12246A-MB71S2
CAN ICES-3 (A)/NMB-3(A)
NOTE: This equipment has been tested and found to comply with
the limits for a Class A digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interfer-
ence to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at his own
expense.
Caution: Changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority to
operate the equipment.
RF Exposure:
This equipment complies with radiation exposure limits set forth for
an uncontrolled environment. This equipment is in direct contact with
the body of the user under normal operating conditions. The trans-
mitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
Under Industry Canada regulations, this radio trans-
mitter may only operate using an antenna of a type
and maximum (or lesser) gain approved for the
transmitter by Industry Canada. To reduce potential
radio interference to other users, the antenna type
and its gain should be so chosen that the equivalent
isotropically radiated power (e.i.r.p) is not more than
that necessary for successful communication.
This device complies with Industry Canada license-exempt
RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and
(2) this device must accept any interference, including
interference that may cause undesired operation of the
device.
To Next Page
Loading...
