Spa Builders SC-CF - Page 18

17SC-CF & SC-MP Service Manual
Flashing Dots & LED Displayed
If keypad display isn't showing correct temperature, carry out the
following tests:
2• Make sure temperature probe
is properly connected.
If it is, replace probe and reset
breaker.
3• Replace Spa Pack if error con-
dition still persists. (Refer to
"How to Replace Spa Pack"
section of this manual.)
1• Verify if temperature probe is
in contact with water and if
cold air from the back could
be affecting readings.
Use foam to isolate probe from
cold air if that is the problem.