SANITIZATION
IMPORTANT:
After sanitizing the machine,
DO NOT rinse or touch areas
that have been sanitized.
Product must be added
immediately. If new product
will not be added
immediately, rinse machine
with clean water and loosen
door hand-screws to allow
cylinder to air-dry. Sanitize
machine before using again.
Turn power switch WASH
Place a bucket or
container below the
draw valve
9
6
Allow solution to agitate for
5 to 10 minutes; NEVER
leave machine on WASH for
more than 10 minutes
OPEN the draw
valve (DOWN) and
drain solution from
the machine
10
7
While agitating, gently use a
clean brush to scrub and
distribute sanitizer solution
along hopper walls
Press RESET button to
stop cycle
11
8
Spaceman USA 6210 Training rev111918
To Next Page
Loading...
