SPALDING 881042 - Pole Section Joining Procedure

15
9.
Stack and bounce the bottom (3) and middle (2) pole sections together. Bounce the pole sections together until
middle pole (2) moves to the 3 1/2” (9 cm) mark you made previously on bottom pole (3).
2
3
Wood Scrap (NOT SUPPLIED)
Identification Sticker
IMPORTANT!
POLE SECTIONS SHOULD HAVE A
3-1/2” (9 CM) MINIMUM OVERLAP.
3-1/2”
(9 cm)
3-1/2”
(9 cm)
Keep ground sleeve cap on bottom pole.
IMPORTANT!
WHEN PROPERLY ASSEMBLED, THE POLE SECTIONS
SHOULD HAVE 3-1/2” (9 CM) OVERLAP.
CAUTION!