TL H.264 DVR User’s Manual
70
• Select <Average Normal PPS> and press ENTER, then press UP/DOWN
to choose a desired number of PPS. The <How Many Days To Record>
will be computed automatically.
• Select <Average Normal Quality> and press ENTER, then press
UP/DOWN to select a desired quality. The <How Many Days To Record>
will be computed automatically.
NOTE: The current number of connected cameras will affect the
recording quality automatically calculated by the <ezRecord
Setup>. Therefore, when there are cameras disconnected or
connected, the <ezRecord Setup> should be reset.
5.4.6 Circular Recording
Users can choose to record video in circular mode or in linear mode. If
circular mode (set to <ON>) is selected, the DVR will store new video data to
overwrite the oldest recorded video. If linear mode (set to <OFF>) is selected
instead, the DVR will stop recording when HDD capacity is full. The
percentage of HDD usage will be displayed at the lower-left corner of the
screen. Furthermore, a reminder message “ALMOST FULL” will show up at
the upper-right corner of the screen when HDD usage reached 98%. In the
mean time, an internal buzzer will start beeping.
From the Record Setup menu, move the cursor to <Circular Recording> and
press ENTER, then select <ON> / <OFF> using UP / DOWN keys.
5.4.7 Audio Recording
This item allows users to enable / disable Audio recording function of the DVR.
When it’s set to <ON>, audio input is recorded and saved with the video.
When it’s set to <OFF>, audio is ignored.
To Next Page
Loading...
