Spectra Precision SP60 GNSS - With FAST Survey

English
21
• Tap on . Make the following additional settings:
With FAST
Survey
• Power on the SP60. Wait until the boot sequence is over.
• On the data collector, launch FAST Survey and open a job.
•In the Equip menu, tap GPS Rover or GPS Base (depending on the
function you want to assign to the receiver). Do the following:
– Current tab: Manufacturer= “Spectra Precision” and Model=
“SP60”.
– Comms tab: Type= “Bluetooth”, find the SP60 Bluetooth
device, select it, tap to establish the connection.
– Receiver tab: Enter the antenna height, and in L-Band only,
choose a datum or enter the parameters of a custom datum if
it is unknown to FAST Survey (see first table below).
SP60 Used As: Parameters:
Network Rover
Modem tab: Select “Current Internet”.
When starting a survey, define the network to connect to (tap
Manage Networks, Add Network...., create then select this
network).
L-Band Rover (RTX)
Survey tab: Choose a datum
General tab: Make sure “L-Band” is selected
SP60 Base/Rover
System Uses:
Receiver
Function
Parameters:
Long-range Blue-
tooth. Set the base
first!
Base
Survey tab: Choose format of corrections
Modem tab: Set Data Modem= “Long-Range Blue-
tooth”
Rover
Modem tab: Set Data Modem= “Long-Range Blue-
tooth”; Scan for base Bluetooth device. Pair with it
Radio link
Base
Survey tab: Choose format of corrections
Modem tab: Choose the model of radio the SP60 is
using. Set the radio.
Rover
Modem tab: Choose the model of radio the SP60 is
using. Set the radio.
Central
Base
(Typically not an SP60)
Survey tab: Choose format of corrections
Modem tab: Select the device you wish to use to let
the base deliver its corrections over the Internet.
Select the network named “Central Cloud Correc-
tions when starting a survey.
Rover
Select the network named “Central Cloud Correc-
tions” when starting a survey.