28
R
EFERENCE
& I
NSTALLATION
M
ANUAL
6.10 BELL SQUAWK ON ARM/DISARM WITH KEYPAD
Section [130] - Arming/Disarming Options
Option [7] OFF = Bell Squawk on Arm/Disarm Disabled (default)
Option [7] ON = Bell Squawk on Arm/Disarm Enabled
When this feature is enabled, the bell or siren will "squawk" once upon arming and twice upon disarming.
6.11 BELL SQUAWK ON ARM/DISARM WITH REMOTE CONTROL
Section [131] - Arming/Disarming Options
Option [3] OFF = Bell Squawk on Arm/Disarm with Remote Control Disabled (default)
Option [3] ON = Bell Squawk on Arm/Disarm with Remote Control Enabled
When this feature is enabled, the bell or siren will "squawk" once upon arming with a remote control and twice upon
disarming with a remote control. Must be enabled for UL installations.
6.12 NO EXIT DELAY WHEN ARMING WITH REMOTE CONTROL
Section [131] - Arming/Disarming Options
Option [4] OFF = Provides Exit Delay When Arming with a Remote Control (default)
Option [4] ON = No Exit Delay When Arming with a Remote Control
With option [4] on in section [131], the control panel will cancel the Exit Delay (arms immediately) when a partition is
armed with a remote control. With option [4] off, the control panel will start the Exit Delay timer when a partition is
armed with a remote control.
6.13 NO EXIT DELAY BEEPS AND NO BELL SQUAWK WHEN STAY ARMING
Section [131] - Arming/Disarming Options
Option [5] OFF = No Exit Delay Beeps and No Bell Squawk When Stay Arming Disabled (default)
Option [5] ON = No Exit Delay Beeps and No Bell Squawk When Stay Arming Enabled
With this feature enabled, the control panel will prevent the bell or siren from squawking and the keypads from
beeping during the Exit Delay, whenever a partition is Stay armed.
To Next Page
Loading...
