Spectra 1728 - 15.11 KEYSWITCH ARMING; 15.12 PANIC ALARMS; 15.13 AUTO-ARMING

58
R
EFERENCE
& I
NSTALLATION
M
ANUAL
One-Touch Regular Arming
Press and hold the [
ENTER
] button for 3 seconds* to arm all zones in the partition.
One-Touch Force Arming
Press and hold the [
FORCE
] button for 3 seconds* to bypass any open Force Zones.
One-Touch Bypass Programming
Press and hold the [
BYP
] button for 3 seconds* to access Bypass Programming Mode.
One-Touch Stay Arming
Press and hold the [
STAY
] button for 3 seconds* to arm all zones not defined as Stay Zones.
Fast Exit - When the system is already Stay Armed:
To Exit and Stay Arm: Press and hold the [
STAY
] button for 3 seconds*. The system will switch to Exit Delay mode.
At the end of the Exit Delay period, the system will return to Stay Arming.
To Exit and Regular Arm: Press and hold the [
ENTER
] button for 3 seconds*. The system will switch to Exit Delay
mode. At the end of the Exit Delay period, the control panel will switch to Regular Arming.
To Exit and Force Arm: Press and hold the [
FORCE
] button for 3 seconds*. The system will switch to Exit Delay
mode. At the end of the Exit Delay period, the control panel will switch to Force Arming.
15.11 KEYSWITCH ARMING
A keyswitch can be used to arm and disarm the system. Assign the keyswitch to a specific partition and program the
keyswitch to Stay or Regular Arm the assigned partition. Also program the keyswitch to function as a Maintained or
Momentary keyswitch. To arm the system using a Maintained Keyswitch, set the keyswitch to the "on" position. To disarm
the system set the keyswitch to the "off" position. To arm the system using a Momentary Keyswitch, set the keyswitch to
the "on" position then turn it back to the "off" position. Repeating this sequence will disarm the system.
15.12 PANIC ALARMS
In case of emergency, the Spectra system provides up to three panic alarms. These panic alarms, if programmed, will
immediately generate an alarm after pressing and holding two specific buttons for two seconds, as described below.
Press and hold buttons [1] and [3] for a panic alarm.
Press and hold buttons [4] and [6] for a panic or medical alarm.
Press and hold buttons [7] and [9] for a panic or fire alarm.
15.13 AUTO-ARMING
You can program the Spectra alarm panel to automatically arm upon the following two conditions. The user is only
allowed to program the Auto Arm Timer. Please note that the control panel will enter a 60-second Exit Delay period
before arming the system. At this point, Auto-Arming can be cancelled by entering a valid access code.
15.14 ALARM MEMORY DISPLAY
A record of all alarm situations that occur will be stored in memory. After disarming the system, pressing the [
MEM
]
button will display which zones were in alarm during the alarm period. To exit the Alarm Memory Display, press the
[
CLEAR
] button. The control panel will erase the contents of the alarm memory every time the system is armed.
* If you have access to both partitions after activating a one-touch feature, press the button corresponding to the
desired partition. To select both partitions, press the [1] key then after the confirmation beep press the [2] key.