SPECTRA SERIES 57
15.8 FORCE ARMING
Force Arming allows users to rapidly arm the system, without having to wait for all zones in the system to be closed.
Force Arming is commonly used when a motion detector is protecting the area occupied by a keypad. Therefore,
when arming the system, if the motion detector is set as a Force Zone, the control panel will ignore the zone and
allow users to arm the system even if the zone is open. Any open Force Zones at the time of arming will be
considered "deactivated" by the control panel. If during this period a "deactivated" zone is closed, the control panel
will revert that zone to "active" status, hence, will generate an alarm if breached.
If you make a mistake, the keypad will emit a "
REJECTION
BEEP
". When correctly Force Armed, the appropriate "
ARM
"
indication will appear and the Exit Delay will be initiated. Please note that Force Arming can also be activated using
One-Touch Force Arming. Also note that the Access Code must have the Force Arming Option enabled.
15.9 MANUAL BYPASS PROGRAMMING
Manual Bypass Programming allows users to program the alarm system to ignore ("deactivate") specified zones the
next time the system is armed. Please note that Fire Zones can not be bypassed and that Manual Bypass
Programming can also be activated using One-Touch Bypass Programming.
*If you have access to both partitions, press the button corresponding to the desired partition. The Access Code
must have the Bypass Programming Option enabled.
15.9.1 BYPASS RECALL FEATURE
After disarming the system, the control panel will erase the bypass entries. By using the Bypass Recall
Feature, you can reinstate the previous bypass entries saved in memory. This eliminates the need to
manually program the bypass entries every time you arm the system.
*If you have access to both partitions, press the button corresponding to the desired
partition. The Access Code must have the Bypass Programming Option enabled.
15.10 ONE-TOUCH ARMING
One-Touch Arming allows users to arm the system without the use of an access code, simply press and hold a
button. One-Touch Arming can be used to allow specific individuals like service personnel (i.e. cleaners,
maintenance) to arm the system when leaving the protected area, without giving them access to any other alarm
system operations.
How Do I Force Arm?
1) All zones in the desired partition (except Force Zones) must be closed.
2) Press the [
FORCE
] button
3) Key in a valid [
ACCESS
CODE
]
IF YOU HAVE ACCESS TO BOTH PARTITIONS:
4) Press the button corresponding to the partition you wish to Arm. To
Arm both partitions, press the [1] key then after the confirmation beep
press the [2] key.
How do I Program Bypass Entries?
1) Press the [
BYP
] button.
2) Key in a valid [
ACCESS
CODE
]*
3) Select one or more [
ZONES
] you wish to bypass
4) Once you have entered the desired bypass entries, press the [
ENTER
]
button to accept these entries.
How Do I Recall Bypass Entries?
1) Press the [
BYP
] button.
2) Key in your [
ACCESS
CODE
]*
3) Press the [
BYP
] button. Previously bypassed zones will illuminate.
4) Press the [
ENTER
] button.
To Next Page
Loading...
