Not a substitute for official published procedural guide
Detailed instructions/videos located at support.spectralogic.com
If two power supplies installed and one supply is functioning normally:
1. Disconnect power cord to malfunctioning power supply
Identify malfunctioning supply by checking for amber status LED on rear of
supply
2. Loosen screws and remove faulty power supply
3. Slide new power supply into library and tighten screws
4. Reconnect power cord
5. Verify power supply is functioning properly by checking for green DC status LED and
blue AC status LED on rear of supply
6. Create an Auto-support Log File (ASL) and forward to Spectra Technical Support
Obtain permission from customer prior to performing this step
ASL’s do not contain sensitive customer information such as passwords,
encryption keys etc.
Reference knowledge base article KBA-02265 (Spectra Support Portal)
7. Package the faulty power supply module and ship it to Spectra Logic
To Previous Page
Loading...
