3-8 Chapter 3: Configuring the Micro800 Expansion I/O 2085-OX32-SC Using CCW
User’s Manual Pub. 0300309-01 Rev. A
Software
Versioning
The software version tracks major and minor revisions for end users.
The shipped software version begins at version 1.1.
Once released, the major revision is typically incremented if new features are
introduced to the product. Otherwise only the minor revision is incremented.
3.4.1 Software Updates
In-field updating of the software by the end user is not supported.
3.4.2 Startup and Factory Default Conditions
During startup, all outputs are OFF until valid communications with the
Controller has been established and the Controller has been placed in Run mode.
There is no input data communication and no signal outputting before the
controller goes into Run mode. All channels are OFF if the module in not in Run
mode. User output controls are only loaded or re-loaded when Run mode is
detected. With the controller in Run mode, and no-fault state in the module, the
module sets the appropriate output channel to the state specified in the output
variables where 1=ON, and 0=OFF as Boolean data type control. If a hardware
fault is detected, all outputs are turned OFF, and the status variables indicate the
last module and channel status.
To Next Page
Loading...