11
The memory of the 2000-Series data logger is not auto-
matically cleared when the logger is downloaded or the
batteries are replaced. The logger can be cleared manual-
ly through SpecWare software. This may be desired if,
for example, the logger is being shut down for the season
or is being moved to a new location.
Once the command is sent from SpecWare to clear the
memory, the data erasure is carried out automatically by
the logger itself. The PC interface cable can then be dis-
connected without affecting the process. A data erasure
will take several minutes to complete and the logger
cannot be contacted in the interim. Once the memory
is cleared, it is impossible to recover. SpecWare pro-
vides warning messages to prevent an accidental clearing
of the memory.
Clearing the
Logger’s memory
To Next Page
Loading...
Need help?
General