8
The data logger has the versatility to be located in any
micro-climate for recording weather data. Hardware is
included for attaching it to a 1” to 1¼” outside diameter
mast (pipe). Use a 5’ - 10’ length of conduit or pipe as the
mast mount. When purchasing and/or cutting the mast to
size, plan on placing 1½’ - 2’ of the mast into the ground.
It can also be mounted to a wooden post with the screws
that are provided.
For all models (except model 2400), the radiation shield
protects the temperature sensor from solar radiation and
other sources of reflected heat. If other sensors are con-
nected, secure the sensor wires to the mast just below the
display module with a plastic tie. This will make the
wires less vulnerable to being accidentally severed during
the season.
Station Installation
To Next Page
Loading...
Need help?
General