14
2. Use arrows to scroll to display units.
3. Press Set.
4. Use the arrow keys to choose data in English or
metric units.
5. Press Set.
Note: The unit system used by the 2000-Series Data
Logger can be modified by both the keypad and by
SpecWare. Although it is advisable to have both the
software and firmware using the same unit system, it is
not required. SpecWare is equipped to handle situa-
tions where it receives data in a different unit system.
However, if you use SpecWare to change any of the
data logger’s configuration parameters (i.e. logging
interval), the data logger will also be reconfigured to
use the unit system used by SpecWare.
DISPLAY UNITS
Press SET
If the display is off, press Display to turn it on.
1. Press Set.
Select Parameter
To Be Set (↑↓)
Setting The
Display Units
To Next Page
Loading...
Need help?
General