Spectrum DX6 User Manual

33
SPEKTRUM DX6 • TRANSMITTER INSTRUCTION MANUAL
EN
FUNCTION LIST


System Setup
Use System Setup to enter the System List from the Function
list without turning the transmitter off. A Caution screen will
appear that warns that RF will be disabled (the transmitter will no
longer transmit). Press YES if you are sure and want to access
the System List. If you are not sure, press NOtoexittothemain
screen and continue operation.
If you do not press YES or NO,thesystemwillexittothemain
screenandcontinueoperationwithinapproximately10seconds.
WARNING: Do not press YES unless the model is turned
off or the model is secured.
Monitor
The Monitor screen displays the servo positions for each channel
graphically and numerically. This is useful to verify programming
functions,trimsettings,mixdirections,etc.Thenumericvalueis
directlyrelativetothetraveladjustandmixvalues(e.g.,100%
travel adjust equals 100% value in the Monitor).

Spectrum DX6 Specifications

General

Channels	6
Modulation	DSMX/DSM2
Model Memory	250
RF Power	100mW
Display	LCD
Battery	4 AA batteries