Spectrum DX8G2 User Manual

39
SPEKTRUM DX8G2 • TRANSMITTER INSTRUCTION MANUAL
EN
ACRO (AIRPLANE)
The possible servo reversing options for a delta wing model are:
Tip: If you test all servo reversing options and the control surfaces
do not move in the correct direction, change the Elevon wing type
in the System Setup list from Elevon-A to Elevon-B.
Aileron Elevator
Normal Reverse
Normal Normal
Reverse Reverse
Reverse Normal
Right
Rudder
Left
Rudder
Up
Elevator
Down
Elevator
Left
Aileron
Right
Aileron
The Flap System menu option enables flap programming as well
aselevatormixing.Youmustselectaap-enabledwingtypein
Aircraft Type or the Flap System menu does not appear.
To activate the Flap System:
1. Access the System Setup list and select Aircraft Type.
2.Selectaap-enabledwingtypeandexittheSystemSetuplist.
3. Access the Function List from the Main Screen and select Flap
System.
4. Select Inhibit and scroll to the switch or lever you wish to use
to control the flap channel.
5.AssigntheFlaptravelvaluesandanydesiredElevatormixing.
6. Select a Flap speed, if desired. Norm (default) does not have a
delay. Flap speed options range from 0.1s to 30 seconds.
Rudder to Aileron/Elevator
RuddertoAileron/Elevatormixingcorrectscouplinginknifeedge
flight.
• AddElevatormixingiftheaircraftpitchestowardthelandinggear
or canopy
• AddAileronmixingiftheaircraftrollsinknifeedgeight
Aileron to Rudder
UseAilerontoRuddermixingtoovercomeadverseyaw
characteristics with certain types of aircraft (such as high-wing
aircraft).
Elevator to Flap
ElevatortoFlapmixingenablesFlapmovementwhentheElevator
stickmoves.UseElevatortoFlapmixingtoaddthespoileron
functionto3Daerobaticaircraft.Thismixisavailablewhenaap
or dual aileron wing type is selected.
Elevon Servo Control
Flap System
ACRO Mixing

Spectrum DX8G2 Specifications

General

Brand	Spectrum
Model	DX8G2
Category	Remote Control
Language	English