101501-565 Rev C Page 54 of 58
6.6.16 Request System Voltages
Description:
The host requests that the firmware report System Voltages.
Direction:
Host to supply
Syntax:
<STX><69><,><CSUM><ETX>
Response:
If an error is detected, the Power Supply responds with:
<STX>69,!,<ERROR>,<CSUM><ETX>
Please reference the Error Code section for a list of valid error codes.
If the message is accepted, the Power Supply responds with:
<STX>68,<ARG1>,<ARG2>,<ARG3>,<ARG4>,<ARG5>,<ARG6>,
<ARG7>,<CSUM><ETX>
Where:
<ARG1> = FPGA Voltage in ASCII
<ARG2> = 24V rail in ASCII
<ARG3> = 15V rail in ASCII
<ARG4> = 5V rail in ASCII
<ARG5> = 3.3V rail in ASCII
<ARG6> = -15V in ASCII
<ARG7> = Spare rail in ASCII
Example Response:.
Slave number 4 has a Fault.
<STX>69,1302,3047,3008,3426,2711,1857,2243,<ETX>
To Next Page
