101501-565 Rev C Page 56 of 58
6.6.18 Program Local/Remote Mode
Description:
The host requests the firmware to switch between Local and Remote
Mode.
Direction:
Host to supply
Syntax:
<STX><99><,><ARG><,><CSUM><ETX>
Where:
<ARG> 1 = Remote, 0 = Local in ASCII format
Response:
If an error is detected, the Power Supply responds with:
<STX>99,!,<ERROR>,<CSUM><ETX>
Please reference the Error Code section for a list of valid error codes.
If the message is accepted, the Power Supply responds with:
<STX>99,$,<CSUM><ETX>
To Next Page
