Spengler PSL50 Series - Clean Spout Adaptor, Mixers, and Black Coffee Kit

11
CL & PSL50 Series
SERVICE TASKS
Step 2: Clean spout adaptor, mixers, Black Coffee Kit
Remove whipper disc - one per mixer
- by gripping and pulling it straight out.
(Medium force is required.)
Disconnect ingredient spouts from
spout adaptor.
Pull spout adaptor forward to
separate it from support arm.
Release mixer by rotating red lever
from 6:00 (locked) position to 7:00
(unlocked) position (A), then pull it
forward to release it (B).
02
03
01
A
B
04
For dispensers with Black Coffee Kit
pull vessel forward to release it from
mounting clip, then pull rear tube off
stem.
Disassemble and clean all parts inside
and out. Dry after cleaning, Set aside.
06
05
Pro Tip:
To make removing the whipper
disc easier, a special Whipper
Disc Tool is available from the
distributor. (Part # 6162028)
Important:
For Annual and Biannual
Services replace the mixer
units with PN10032974 and
PN10011038. Dispose of all used
parts in the appropriate recycling
bins.