Spengler PSL50 Series - Install Monobrewer Service Kit

17
CL & PSL50 Series
Step 5: Install monobrewer service kit (annually & biannually)
SERVICE TASKS
Press ejector button to release
lter and gasket from chamber
bottom. Replace with new lter and
gasket included with kit.
Remove screw securing shower head
and silicone plate. Pull off o-ring.
Replace with new silicone plate and
o-ring included with kit.
Remove o-ring from water inlet.
Replace with new o-ring included with
kit.
01
Pull old scraper blade off of grounds
scraper. Replace with new blade
included with kit.
05
07
06
Slide cylinder out of bottom of brewer. Slide cylinder back into brewer. Pull silicone nipple holder out of
brewer. Replace new nipple included
with kit in holder and replace in
brewer.
02
03
04