Spengler PSL50 Series - Clean Monobrewer

16
CL & PSL50 Series
Step 5: Clean monobrewer
SERVICE TASKS
Grip monobrewer at bottom and
rotate it upwards approx. 25° to
release it from housing to remove it.
Disconnect monobrewer’s outlet tube.
Remove safety cover.
02
01
03
Important:
For Annual and Biannual
Services rebuild the brewer
with PN10037202 (coffee
versions) or PN10037220
(tea versions). Dispose of all
used parts in the appropriate
recycling bins. Refer to “Install
monobrewer service kit” for
instuctions.
04
Rotate exposed gear cog at back of
monobrewer (A) so chamber base
at bottom is fully opened. Then slide
grounds scraper out from back (B).
B
Rotate exposed gear cog at back of
monobrewer (A) so both chamber top
(B) and chamber bottom (C) are both
fully opened.
Slide grounds guide (A) out from back, then pull chamber top
out (B). Rotate gear cog up then pull chamber bottom out
(C). Wash all parts under running water and scrub away any
dried coffee residue with brushes. Dry after cleaning. Set aside.
05
B
C
06
A
B
C
A
A
Pro Tip:
If opening the monobrewer by
rotating the gear cog at the back
of the brewer proves too difcult
to perform by hand, use an
8mm wrench to rotate the shaft
connecting the gear sets.