Spengler PSL50 Series - Reassemble Espresso Brewer

15
CL & PSL50 Series
Step 4: Reassemble espresso brewer
Insert espresso outlet so tube points
away from the centre of brewer to
align retaining nib to release position,
then push it into brewer cover and
rotate it 180° to lock it in place. Set
aside.
Slide grounds pusher into its track
and push it back until it just extends
past the back of the brewer.
Fit brewer cover into guide slots
(when correctly aligned brewer cover’s
outlet tube orice will be pointing to
right - when viewed brewer from front
- brewer cover cannot be successfully
installed backwards).
Slide cake pusher and brewer cover
towards each other so that cake
pusher’s guide nibs align into brewer
cover’s corresponding slots and then
push brewer cover down until it is
fully seated to brewer.
02
01
03
04
SERVICE TASKS