SPHINX Myth5 - 6 Sphinx Remote Control; Buttons and LED Indication

SPHINX Myth 5
9
6. SPHINX REMOTE CONTROL
This single Sphinx Remote Control lets you control
all functions: not only of the Myth 5, but of all other
Sphinx equipment.
Only the following buttons and indications of the
Remote apply to the Myth 5 (the others will not
function):
Buttons and LED indication
1. PRE-AMP: To select the amp. All buttons
pressed hereafter will only control the amp
functions.
The buttons TUNER, CD and will have no
effect on the amp.
2. STANDBY: Use this red button to switch the
loudspeaker outputs of the Myth 5 off (stand-by).
Pressing this button has the same effect as
pressing the MUTE button on the front panel.
The headphone output will remain active though!
3. TAPE/MONITOR: Use this button to select the
Tape IN input. Pressing this button has the same
effect as pressing the TAPE button on the front
panel.
Note: The LED of the selected input (see 4.) will
remain illuminated.
4. 1 - 4: To select inputs CD to Line 2 (Note: 5 to 0
do not function):
1 CD
2 Tuner
3 Line 1
4 Line 2
5. Volume ñ: Pressing this button has the same
effect as clockwise rotating the VOLUME control
on the front panel. You will increase the volume.
6. Volume ò: Pressing this button has the same
effect as anti-clockwise rotating the VOLUME
control on the front panel. You will decrease the
volume.