SPHINX Project Two Mk2 - Care and Maintenance Guide; Cleaning and Surface Care; Sphinx Project Two Mk2 Technical Specifications

SPHINX Project Two Mk2
11
7. CARE AND MAINTENANCE
Clean the exterior with a soft, lint-free, anti-static
cloth. Do not use force while wiping the surface.
To remove difficult stains use a few drops of
detergent on a moist cloth, sweep carefully and
wipe dry afterwards.
If some scratching occurs, please first consult your
Sphinx dealer. He can give you advice about
possible solutions.
Do not use polishing or cleaning agents: they
may damage the sensitive acrylic finish.
Do not use aerosol cleaning agents.
Most contain solvents which might actively react
and damage the acrylic finish.
8. TECHNICAL SPECIFICATIONS
Bandwidth 0 - 500,000 Hz (+0/-3 dB)
Phase response error <0.5°
Gain 18 dB max.
THD+N (IHF-A) <0.0015% (2nd harm., 10 - 20,000 Hz)
IMD <0.003%
S/N ratio (IHF-A) >100 dB
Channel separation >100 dB
Inputs 1 x XLR balanced
5 x cinch unbalanced (goldplated)
level, nominal (for 1 V output) 0.13 V (-18 dBV)
impedance
XLR: 10 kΩ / cinch: 50 kΩ
Outputs 1 x XLR balanced
2 x cinch unbalanced (goldplated)
1 x cinch Tape (goldplated)
level 9.2 V max. (19.3 dBV) (1 - 100,000 Hz, THD <0.002%)
impedance
<10 Ω
Volume control ALPS motorized
channel imbalance less than 2 dB
Sphinx Control 1 x optical
Remote control Full function
Mechanical decoupling of housing Transrotor absorbing 'pucks'
Power supply External, completely stabilized
Supply capacitance 35,200 µF total
Power consumption 15 W stand-by
17.5 W 'on'
Dimensions (h x w x d) 68 x 482 x 328 mm
Weight 11 kg
This unit conforms to the EMC interference regulations from the EU and to the CE standards.
This unit complies with safety regulation VDE 0860 and thus with international safety regulation IEC 65.
Technical specifications can be changed by SPHINX without prior notice if technical developments make this
necessary.
©1999 Audioscript BV