Not to be distributed without prior consent of SPI Lasers UK Ltd.
Slide: 7
FS-S00149-Rev A
Customer Requirements Pre Install
Electrical Connections
29/06/2016
Mains DC Power Supply
Electrical power for the pump diodes must be provided by an external DC power supply.
Power for the internal electronics must be provided by a DC auxiliary power supply.
SPI Lasers recommends the following DC power supplies for the pump diode supply
• Customer sourced Power Supply
• Customer must follow Supplier instruction Manual for Parallel Operation if more than one power supply to be used.
• Must conform to the specifications in the following slide for EOL (End Of Life) Current and Voltage.
• TDK Lambda GEN 50-200-3P400
• Aux 24V PSU(0.5A Rated) 24 ±5% Isolating
• MEAN WELL RST-10000-48
• May require additional Capacitive Support for first few
milliseconds of operation. See Figure below.
To Next Page
Loading...