SPIERINGS AT4 - 4.3. Engine Oil Filter

USER MANUAL SPIERINGS TRUCK AT4
AT4-EN-041115.doc
4-4
4.3. Engine oil filter
4.3.1. Oil filter replacement
Replace the oil filter after every 15.000km or during the yearly maintenance service at
normal working conditions.
Always replace the oil filter for a new one. A used filter may never be cleaned and used again.
1. Place a trough under the filter.
2. Unscrew the filter by means of an oil filter wrench.
Picture 4-5
3. Fill the new filter element with engine oil.
4. Oil the new filter element seal ring with engine oil.
Picture 4-6
4. Mount the filter until the seal makes contact, then tighten the filter with
45 Nm torque.
5. Important: after changing oil and mounting the filter, operate the
vacuum brake and let the engine run by means of the starter motor
until the oil pressure indicator lamp goes out.
6. Leave the engine running for a short while and make sure the oil filter
is properly sealed.
7. Now check the oil level.
Picture 4-7