Spin pro Series - Controller SPIN Pro OPTO; Connecting the Controller; General Conditions for Connecting the Controller

www.modellmarkt24.ch
Basic parameters of SPIN OPTO controllers:
Type
Sustained
current
[A]
Input
Voltage
[V]
BEC
[A]
BEC
[V]
Dimensions
[mm]
Weigt
[g]
SPIN 66 opto pro
70
6 - 26
-
-
52x25x12
45
SPIN pro75 opto
75
12 - 42
-
-
52x25x15
55
SPIN pro77 opto
77
12 - 50
-
-
65x55x17
110
SPIN pro99 opto
90
12 - 50
-
-
65x55x17
110
SPIN pro125 opto
125
12 - 50
-
-
65x55x25
120
SPIN pro200 opto
170
18 - 59
-
-
63x120x27
326
SPIN 300 opto pro
220
18 - 59
-
-
63x120x27
360
1.2 SPIN pro OPTO Controllers:
These controllers have galvanically separated input (signal from receiver) from power
accumulators, therefore it's necessary to use independent supply for receiver and servos
(4-5 NiXX or 2-3 LiXX with linear voltage regulator, such as MAX BEC).
SPIN OPTO controllers are provided with two JR connectors. Connector on longer three-
line cable with black ending is to be linked to the receiver. Connector on shorter
three-line cable with red ending is intended for communication with JETI BOX; for
programming or data reading connect it into slot marked imp. + - on JETI BOX.
2. Connecting the controller
2.1 General conditions for connecting the controller:
apply only new high quality connectors properly soldered to the cables.
for controllers SPIN 11 and SPIN 22 we recommend to use G2 connectors, for higher
types G3.5 or G4. After soldering the connectors, check that the springy front part remains
rotary. It may happen that the flux rises along the connector surface and in the worst case
galvanically separates the springy part from the connector body. A remedy is possible by
brushing the connector with nitro diluent. During the operation, observe that the
connectors stay clean and the plug-in force remains high. If this force decreases, replace
the connectors immediately.
•
•
We recommend replacement of connectors after 1-2
flight seasons.
EN
SPIN SPIN
PROPRO
18
www.modellmarkt24.ch