Spin pro Series - Page 21

www.modellmarkt24.ch
single tones - Mode 1 Acro inrunner:
- this mode is appointed to aerobatic models driven by motors of
classic conception. (inrunner)
- brake not active
- timing 0°
- LiXX-3,2V per cell
two tones - Mode 2 Acro outrunner:
- this mode is appointed to aerobatic models driven by motors of
the reversed conception (outrunner).
- brake not active
- timing 24°
- LiXX-3,2V per cell
groups of three tones - Mode 3 Glider inrunner:
- this mode is appointed to gliders driven by motors of classic
conception (inrunner).
- brake activated
- timing 0°
- LiXX-3,2V per cell
groups of four tones - Mode 4 Glider outrunner:
- this mode is appointed to gliders driven by motors of the reversed
conception (outrunner).
- brake activated
- timing 24°
- LiXX-3,2V per cell
groups of five tones - Mode 5 Heli constant RPM:
- this mode is appointed to model helicopters with the claim or
constant speed regulation with changing load/unload of the rotor.
This mode does not support fast speed changes
- timing 0°
- LiXX-3,2V per cell
groups of six tones - Mode 6 Heli Auto:
- the same like mode 5, but RPM range is set automatically
- LiXX-3,2V per cell
Confirmation of the setting is carried out by shifting back the throttle
to low throttle position during the tone signals of the factual mode.
position is stored in the memory (END POINT), otherways follow groups of five repeating tones
according to the appropriate mode:
Rx Power ON
First melody
Brake
Acro inrunner
5s
Acro outrunner
Glider inrunner
Glider outrunner
Heli constant RPM
time
t
Tx Power ON
Setting saved
()
Heli Auto
1
2
3
4
5
6
EN
SPIN SPIN
PROPRO
21
www.modellmarkt24.ch