Spiricon LBA-300 - Page 227

Key Type Value Description
Operator’s Manual LBA-PC
Doc. No. 10654-001, Rev 4.10
227
1 to 100000.
CameraInput B Which camera input is in use. Cannot be
set. To select which camera is in use, set
only one of the CameraInput# below.
0, or 1 to 3 if you purchased the four-
camera option.
CameraInput2
CameraInput3
CameraInput4
B Which camera input(s) to use. Valid only
if you purchased the four-camera option.
CameraShutter L Camera shutter setting for camera 1.
0 to 7. Effect depends on camera.
CameraShutter2
CameraShutter3
CameraShutter4
B Camera shutter settin
g
for cameras 2 to 4.
Valid only if you purchased the four-
camera option.
0 to 7. Effect depends on camera.
CameraGainEffect F Camera input gain for camera 1.
1.0 to 5.0, equivalent gain multiplier effect
CameraGainEffect2
CameraGainEffect3
CameraGainEffect4
F Camera input gain for cameras 2 to 4.
Valid only if you purchased the four-
camera option.
1.0 to 5.0, equivalent gain multiplier effect
CameraBlack I Camera input black level for camera 1.
0 to 511.
CameraBlack2
CameraBlack3
CameraBlack4
I Camera input black level for cameras 2 to
4. Valid only if you purchased the four-
camera option.
0 to 511.
TriggerType L Trigger type.
0 = cw
1 = out
2 = video
3 = in
TriggerOutAlways B Trigger out always enable.
TriggerOutDelay B Trigger out delay enable.
TriggerPolarity L Trigger out polarity.
0 = negative
1 = positive
TriggerInterval I Frames between triggers.