Need help?Do you have a question about the Spirit XR895 and is the answer not in the manual?
General| Flywheel Weight | 30 lbs |
|---|---|
| Programs | Manual, Interval, Fat Burn, Cardio, Strength, User (2), HR (2) |
| Resistance Type | Magnetic |
| Handlebar Adjustment | Yes |
| Transport Wheels | Yes |
| Console Display | LCD |
| Display Type | LCD |
Unscrew 4 Phillips Head Screws (99) with a Phillips Head Screw Driver (114) to release the Console.
Remove Handle Bar Cover (141), use a 12/14 m/m wrench to release screws and washers to detach the Handlebar Assembly (3).
Use a 13/15m/m wrench to turn the Left Pedal (116) clockwise and Right Pedal (117) counterclockwise to disassemble them.
Use a Phillips Head Screw Driver to release 7 Self Tapping Screws (103) and 2 Tapping Screws (102) for the Left Front Chain Cover (29).
Unscrew 2 Self Tapping Screws (107) with washers on the mainframe, then unscrew 2 Tapping Screws on the cover and unplug wires.
Check computer cable insertion and connecting cables between generator flywheel and controller for a blank console display.
Rubbing noises are usually due to Round Disk Cover alignment or rubbing between Crank and Chain Covers.
If belt falls off, check chain covers, idle arm, drive pulley, and generator flywheel alignment.
Tightening M8x7T Nut (88) on M8 x 170J-Bolt (87) will fix the problem of belt slippage.
If the cylinder cannot function properly, replace it following Step 8.
To Next Page
