Date of issue: March 2016 Revision 2 Page 44/80
- Reassemble all the components of the beater,
taking care to observe the correct alignment as
shown in fig. 39 and 40. These components are:
• Central shaft L (fig.39);
• Two scrapers N (fig.39);
• The two rear seals M and O taking care
to insert first the one with the metal grey
bushing (M) and then the one with the
white plastic bushing (O) as indicated in
figure 40.
!ATTENTION!
The position of the rear seals M and O is of
fundamental importance to the proper
functioning of the appliance. Pay particular
attention to the correct mounting alignment
shown in fig. 40 where the rubber cup M is
pointing towards the auger flange while the
rubber cup O is pointing towards the rear of the
cylinder. Incorrect positioning of the rubber cup
can cause serious damage to the appliance.
!ATTENTION!
The two rear seals M and O have been designed
to work without any lubrication, for this reason
they have never to be lubricated. Failure to
comply with this requirement can cause serious
damage to the appliance.
!ATTENTION!
The position of the scrapers N is of fundamental
importance to the proper functioning of the
appliance. Pay particular attention to the correct
mounting direction shown in fig. 41. Incorrect
positioning of the rubber cup can cause serious
damage to the appliance.
Fig. 39
Fig. 40
Fig. 41
To Next Page
Loading...
