SPM U-go - Start-Up Procedures and Method of Use

Date of issue: March 2016 Revision 2 Page 33/80
8. START-UP PROCEDURES AND
METHOD OF USE
!ATTENTION!
BEFORE STARTING THE APPLIANCE THE FIRST
TIME, CARRY OUT THE CLEANING AND
SANITISING PROCEDURES DESCRIBED IN
CHAPTER 9.
- Dilute and mix the preparation in a separate
container according to the manufacturer’s
instructions (fig. 4).
NOTE: The blending of water or milk with
the preparation is called the mix and
makes soft serve ice cream and similar
products.
!ATTENTION!
Never use the appliance with unsuitable
products different from the specific soft ice
cream ones. Failure to observe this instruction
may cause irreparable damage to components
of the appliance.
When you produce a new flavour of ice cream
and you start up the appliance for this purpose,
we recommend starting by introducing only 1.5
litres of mix needed to fill the freezing cylinder
and introduce the remaining product into the
top tank only after placing the compression pipe
as a junction between the freezing cylinder and
the pump.
- Remove the top tank lid (fig. 5).
- Rotate the compression pipe clockwise in order
to disconnect it from the pump (fig. 6).
- Pull the compression pipe upwards in order to
disconnect it also from the freezing cylinder
connection pipe (fig. 7).
Fig. 4
Fig. 5
Fig. 6
Fig. 7