SPRIANO SST70 - Page 26

OPERATING MANUAL
MN-SST70
ED-19-01
SPRIANO® TECHNOLOGIES - www.spriano.it – spriano@terranova-instruments.com
a TERRANOVA® Srl brand - www.terranova-instruments.com - VAT IT07848810151
Factory & Sales: Via Gramsci 1 – 26827 Terranova dei Passerini (LO) – Italy
Head Office: Via Rosso Medardo 16 – 20159 Milano – Italy Ph: +39 0377 919119 – Fax: +39 0377 855720
Pag.26/52
Function
Display name
Use
Choice span
Full span
setting
URV
Indicates and allows you
to manually enter the
final value of the interval
(the value corresponding
to the 20 mA value). The
unit of measurement is
displayed at the bottom
right of the screen.
Between the
sensor limits
Measuring unit
selection
PV UNIT
Measuring unit selection
from the available ones.
Press  o  to scroll.
Level
(Interface):
m, in, cm, mm
Density
Kg/l
Sensor
Temperature
unit
TEMP.UNIT
Selecting of the display
mode associated with
primary variable. Push 
o  buttons to scroll.
°C, °K, °F
Configuration
of the
measuring unit
typology
XFR FUNC
Selection of the
measuring typology
(LINEAR or DENSITY)
LINEAR
DENSITY
Fault
configuration
ALARM TYPE
Fault condition analog
output selection.
NONE = no
action
21mA
3.85mA
LAST = last read
value
Damping
setting
DAMP VALUE
Insert the signal
averaging time constant.
0 ÷ 60s
4mA input
automatic
setting (zero)
SET LRV
At button pushing, the
instrument modifies the
value of LRV and places
it equal to the currently
measured value. In this
way, the analog output is
4 mA.
-